Directed Electronics s650 Car Speaker User Manual


 
7
© 2003 Directed Electronics, Inc
TWEETER INSTALLATION
Review the
Installation Precautions
section of this guide before proceeding.
Flush Mounting into
Removed Panels
1. Determine the tweeter mounting
location, then route the wires from
the crossover to the tweeter location.
2. Mark the center point of the tweeter
location.
3. If using a hole saw, first drill a pilot
hole, then cut out the hole using a
standard 2-1/8" hole saw.
4. If not using a hole saw, use either
the cardboard packaging for the
tweeters or the surface mount trim
ring as a template to mark the
proper size hole. Cut out the hole.
5. With the tweeter assembled, route
the wires through the hole and the
pressure ring and slip the pressure
ring over the tweeter assembly.
6. Align the tweeter so the Directed
logo faces the desired direction then
push the pressure ring on to the rear
of the tweeter assembly until the
tweeter is snugly mounted to the
panel.
7. Connect the speaker wires observing
the correct polarity and re-assemble
the panel.
DRW-12
FLUSH MOUNT
TWEETER
ASSEMBLY
PRESSURE
RING
WIRING HARNESS
TWEETER WIRE
FIGURE 2—FLUSH MOUNTING REMOVED PANELS