Filter
Top Products
SSIIGGNNAALL SSOOUURRCCEE SSEELLEECCTTIIOONN
Select the input signal for viewing (AV1 or AV2) by momentarily pressing the ( )
button on the LCD screen or the MODE button on the remote.
OONN//OOFFFF CCOONNTTRROOLL
Press and hold the ( ) button on the LCD screen or press the POWER button on the
remote.
FFUUNNCCTTIIOONN MMOODDEE ((MMEENNUU))
Press the MENU button on either the LCD screen or the remote to display the fol-
lowing setup options:
COLOR
BRIGHT
TINT
SHARPNESS
CONTRAST
DIMMER
FORMAT (Normal, Full, Zoom)
RESET (restore factory default settings)
Once the desired setting is selected use the cursor buttons to change the setting.
After 5-seconds of inactivity the MENU screen will turn off.
DDOOOORR LLIIGGHHTT OONN//OOFFFF
Press this switch on the LCD screen to have the door open sensor operate the dome lights.
NNOOTTEE::
This feature is operational only if the Gray or Purple door lock trigger wires have been
connected to the door sensor.
The dome light selector switch contains two separate circuits. One for a positive
dome light trigger and one for a negative dome light trigger. Please refer to the
wiring table below for each of these triggers.
1122
© 2004 Directed Electronics, Inc.