19
XDMA6700 OPERATION
Bluetooth
®
Operation (Optional)
Overview
Connecting a Bluetooth device requires first connecting the Dual BTM60 module (sold
separately). When connected to a Dual Bluetooth Ready head unit, the BTM60 supports
the HFP (hands-free profile), A2DP (advanced audio distribution profile) and AVRCP (audio
video remote control profile).
Preparation
Before you can use a mobile device with this head unit, it must be connected and
authenticated - commonly referred to as "pairing" a device. Please make sure that
Bluetooth is activated on your mobile device before you begin the pairing process. Refer
to the owner's manual of your mobile device for more details.
Bluetooth Pairing
1) To pair a Bluetooth enabled mobile phone to your head unit, press on the head unit
or BTM60, or press MODE until "DUAL_BTM60" is displayed.
2) Press and hold
on the head unit or the BTM60 for 5 seconds, until "PAIRING"
is displayed, the Bluetooth icon will flash every second. The head unit will begin to
broadcast a signal for 60 seconds.
3) Complete the pairing from the Bluetooth menu of your mobile device by searching for
new devices. Please refer to your mobile device instructions for further information on
Bluetooth pairing and connections. The Bluetooth icon will illuminate solid.
The BTM60 device name is "DUAL_BTM60."
The password for the DUAL BTM60 is 1234.
General Notes
•Due to the differences in Bluetooth technology, some mobile devices may be
incompatible or function improperly when used with the BTM60.
•The BTM60 will store the last eight (8) devices that have been paired in its memory. If
more than eight devices are paired, the head unit will remove the oldest device from its
memory and that device will have to be paired again.
Connection Notes
•If ACNT is set to OFF, you must press to connect after pairing.
•From Bluetooth standby mode, press MUTE to disconnect your mobile device from the
BTM60.
•From Bluetooth standby mode, press to reconnect your mobile device to the BTM60.
•To connect a different mobile device, the currently connected mobile device must be
disconnected. If this device has been paired previously, you may reconnect using the
mobile device's Bluetooth menu, or repeat the above pairing instructions.