Filter
Top Products
3
Mounting
• Open splashguard and detach side covers by pulling outward from the inside of side
cover.
• Insert supplied mounting bolts through washers and into mounting holes as shown
below.
• Place gasket between back side of splash guard and mounting surface and secure the
splash guard in place with supplied nuts.
• Install head unit into splash guard opening. This may vary depending on head unit
manufacturer and installation instructions. Refer to head unit owner’s manual for
details.
• Reattach side covers by aligning them and pushing firmly into place.
SG3/SG4 INSTALLATION
Mounting
TYPICAL MOUNTING
*Head Unit not included.