Filter
Top Products
13
SETTING THE CLOCK
1.) Switch the unit to Standby mode by pressing the STANDBY/ON button.
2.) Press and hold the MEMORY/CLOCK button. “ 24 H ” (24 Hour format) will flash
in the display. Press the or button to select “ 12 H ” (12 Hour format).
3.) Press the MEMORY/CLOCK button. The hour digit will flash.
Press the or buttons to set the correct hour. Be sure to set correctly for
AM or PM.
4.) Press the MEMORY/CLOCK button again. The Hour is now set and the Minute
digits start to flash in the display.
5.) Press the or buttons to set the correct minute.
6.) Press the MEMORY/CLOCK button again. The Minutes are now set and the clock
will start to run.
NOTE:
• Clock time is only retained while the unit is plugged into the AC outlet. In
the event of a power failure the clock will need to be reset when the power
supply resumes.
• Clock time is only shown when unit is in Standby mode.
ES58_012904.p65 29/1/2004, 15:2413