Fender XP 112 Car Speaker User Manual


 
5
The XP Series Loudspeaker Systems’ 1/4" jacks are
wired in parallel allowing any one of the connectors to
be used as an input and any other as an output. This
allows "daisy chaining" of multiple loudspeakers,
eliminating the need for several long, cumbersome runs
of speaker cable (see diagram on page 6). Their
connections are as follows:
Polarity Phone Jack
Positive (+) Tip
Negative (-) Sleeve
If XP enclosures are used as the mid / high pack in a
larger three-way loudspeaker array, an external
crossover may be used with the speaker and two
channels of power amplification will be required: one for
the low frequencies and another for the high frequencies
(see diagram on page 7).
The placement of any speaker can dramatically affect
its sound. Thus, there are several considerations to
review when placing loudspeakers.
First, the range of the horizontal coverage should be
determined. The speaker may be used as a single unit,
as part of a pair, or as part of a group of widely spaced
enclosures, in any case, maximum horizontal coverage
will be desired. Examples of these types of setups
are shown. The horn in this configuration has a
horizontal coverage angle of 70º and a vertical
coverage of 35º.
NOTE: When setting up your XP Series enclosures, be
sure to place the cabinets in such a way as to minimize
overlapping radiating patterns.
A second consideration is for feedback and bass
performance. If the speaker is placed near a large, flat
wall, the bass output will increase by approximately 6
dB. Placing the speaker near a wall can cause
feedback. If this occurs, the speaker must be moved.
A third consideration is to what degree the speaker
should be "heard and not seen", especially in
permanent installations. Remember, where the
speaker cabinets are placed will effect both their tone
and radiating patterns.
XP Series cabinets are covered in a
tough, soil resistant synthetic
indoor/outdoor carpet for long life and
lasting good looks. To clean the
carpeted cabinet, use a brush to wipe
away any smudges or dirt. For stubborn
stains, a sponge with a light soapy
solution may be used. Avoid spilling liquids on the
input panel, grille and speakers.
XP SERIES SPEAKER CONNECTIONS
SETUP SUGGESTIONS
Two speakers arranged as a mono or stereo
pair requiring maximum horizontal coverage
Audience
Stage
XP
Cabinet
XP
Cabinet
Two speakers in a "loose pack" array
requiring maximum horizontal
coverage
30º
XP
Cabinet
XP
Cabinet
CARPET COVERING CARE