Filter
Top Products
Important notes
Important notes
ImportantnotesNotes
In this chapter you will find information regarding safety which it is essential to
take note of when working with your device .
Safety instructions
This device complies with the re
levant safety regulations for data processing equipment,
including electronic office ma
chines for use in an office environment. If you have any
questions, contact your sales
outlet or our H elp Desk.
• The display surface of the devi
ce is sensitive to pressure and scratches. You should therefore
be careful with the display sur
face in order to avoid lasting damage (scratches).
• If the device is brought into the installation site from a cold environment, condensation
can form. Before operating the device, wait until it is absolutely dry and has reached
approximately the same temperature as the installation site.
• When installing and operatin
g the device, please observe the notes on environmental
conditions in Chapter "
Tech
nical spec ification " , Page 26 as well as the instructions in
Chapter "
Setting up an ergon
omic video workstation", Page 8.
• To ensure sufficient ventilation, the air inlet and outlet openings of the device must be kept clear.
• The device automatically set
s itself to the correct voltage within the range from 100 V to 240 V.
Make sure that the local mains
voltage is neither higher nor lower than this range.
• Ensure that the power socket on the device and the mains outlet are freely accessible.
• The ON/OFF switch does not di
sconnect the monitor from the mains voltage. To discon nect
fully from the mains supply,
disconnect the power plug from the socket.
• The device is equipped with a power cab le that complies with safety standards.
• Use the supplied power cable o
nly.
• Lay the cables in such a way that they do not create a hazard (danger of tripping)
and cann ot be damaged. When connecting the device, observe the relevant
notes in chapter "
Connecting the device", Page 12.
• No data transfer cables shou
ld b e connected or disconnected during a thunderstorm.
• Make s ure that no objects (e.g. jewellery chains, paper clips, etc.) or liquids get
inside the device (danger of electric shock, short circuit).
• The device is not waterproof!
Never immerse the device in water and protect
it from spray wat er (rain, se
a water).
• In emergencies (e.g. damaged casing, elements o r cables, penetration of
liquids or fo reign matter), switch off the device, disconnect the power plug and
contact your sales outlet or our Help Desk.
• Repairs to the device must o
nly be performed by qua lifie d technicians. Unauthorised opening
and incorrect repair may gr
eatly endanger the user (electric shock, fire risk).
• Only use the screen resolution se ttings and refresh rates specified in C hapter
"
Technica l spe cification", Page 26. Otherwise you may damage the device. If you
are in any doubt, c ontact your sales outlet or our H elp Desk.
• Use a screen saver with movi
ng images and activate the power management for
your monitor to prevent sti
ll images from "burning in".
• If you opera te the device with the swivel arm or wall bracket, it must not be turned by 180°.
A26361-K1317-Z220-1-7619, edition 2 3