Filter
Top Products
-2-
595-5506-10
12
345
6
7
8
4. Mount push button. Use either screws or
double sided tape to mount push button.
To mount with screws, remove back of case by
pushing in tab on bottom with a small screw
-
driver.
Attach back of case to door jamb or wall. Snap front
of push button on.
When attaching push button using double sided
tape, make sure the surface of the door jamb or
wall is clean.
5. Mount chime. There are two different ways to mount the chime depending
upon the model of chime purchased. Determine which model you purchased
below. Mount the chime according to the instructions for your chime.
Chime with sawtooth hanger attached to back:
1. Drill 1/4" diameter pilot hole for wall anchor (provided) and insert anchor.
2. Screw #8 screw (provided) into anchor. Leave 1/16" gap between screw
head and wall.
3. Place hanger over screw to mount chime.
Jumpers
Chime Volume
Sawtooth Hanger
Figure 4
Figure 3