Filter
Top Products
IMPORTANT
Installation of automotive stereo components
can require extensive experience performing
a variety of mechanical and electrical proce-
dures. Although these instructions explain
how to install a Kappa Perfect component
system in a general sense, they do not
show the exact installation method for your
particular car. If you feel you may not have
the necessary tools or experience, ask your
authorized Infinity car audio dealer about
professional installation options.
WARNING
Playing loud music in your automobile can
permanently damage your hearing as well
as hinder your ability to hear traffic. We
recommend listening at low volume while
driving. Infinity accepts no liability for hear-
ing loss, bodily injury or property damage
resulting from use or misuse of this product.
A NOTE ABOUT SYSTEM PERFORMANCE
For the best performance possible, the
Kappa Perfect components should be used
with a two-channel amplifier with output
power of at least 50W RMS per channel.
The passive
crossover contains impedance-
compensating
circuitry and has been
computer-optimized for the flattest possible
frequency response with the tweeter flush-
mounted, on-axis with the listener. The
combined responses of the speakers and
passive crossover constitute a 4th-order
Linquitz-Riley
acoustic alignment and cannot
be duplicated
with any electronic crossover
currently available for car audio use.
Consequently, bi-amping a Perfect
component system with an electronic
crossover is not recommended.
SPEAKER PLACEMENT
Figures 1–4 show possible speaker place-
ments in the order of most desirable to
least desirable. Kick-panel mounting will
provide the best staging and imaging in
most vehicles.
TWEETER INSTALLATION
TWEETER
on dash
WOOFER
in factory-
door location
TWEETER
on kick panel
WOOFER
in factory-
door location
TWEETER
and
WOOFER
on kick panel
WOOFER
in factory-
door location
TWEETER
in high/forward
location on door
Fig 1
Fig 3
Fig 2
Fig 4
Figure 1.
Mounting the woofer and tweeter in
the kick panels
Figure 2.
Mounting the woofer in the door and
the tweeter in the kick panel
Figure 3.
Mounting the woofer and tweeter in
the doors
Figure 4.
Mounting the woofer in the door and
the tweeter in the dash
1
2
–
+
1
2
–
+
red
blk
Figure 5.
Surface-mounting the tweeter
Figure 6.
Flush-mounting the tweeter
- 2 -