Filter
Top Products
ENGLISH 11-0309
© 2011 BBY Solutions, Inc. All rights reserved. All rights reserved. INSIGNIA is a trademark of BBY Solutions, Inc.
Registered in some countries. All other products and brand names are trademarks of their respective owners.
5 Press and hold the CONNECT button on your subwoofer for more than three seconds to
put it into joining mode.
• When successfully joined, the power indicators on both products will stop
blinking and stay on.
• If joining fails after 30 seconds, the power indicators will begin flashing at a
slower rate. If this occurs, repeat the above steps.
Setting the low pass filter
Setting the low pass filter lets you select the frequency range of the sound that your
subwoofer will reproduce and amplify. Turning the knob counterclockwise to 80 Hz sets
the subwoofer to reproduce frequencies lower than 80 Hz. Turning the knob clockwise to
150 Hz sets it to reproduce frequencies lower than 150 Hz. The best setting depends on
the other speakers you are using with the subwoofer. If you are unsure of the best setting,
set this at 150 Hz.
If you are using the subwoofer in wireless mode with a Rocketboost enabled AV receiver or
soundbar (for example Insignia NS-AV511 or NS-SBAR/NS-SBAR-A), you don’t need to set
the low pass filter. These products send a pre-filtered audio stream to the subwoofer that
is set to best match the frequency range of those products.
If you are using the subwoofer in wireless mode with Rocketboost-enabled Insignia TV
models NS-32E859A11 or NS-42E859A11, set the low pass lter to 150 Hz.
Listening to music and setting the volume
1 Turn on your subwoofer and audio source. The power indicator LED on the subwoofer
should light steadily. If it is blinking you need to rejoin the subwoofer to your
Rocketboost hub device. For more information on connecting your subwoofer for
wireless mode, refer to your User Guide.
2 Play music or a movie that you can easily hear the bass sound on.
3 Start with the volume level of the sub at its maximum setting. If you are not hearing the
audio that matches the music or movie you are playing, press the Next Source button
on the subwoofer until you can hear it. This is because Rocketboost receivers (including
the subwoofer) can receive audio from any Rocketboost sender in your network. Each
time you press the Next Source button, the wireless receiver (in this case the
subwoofer) moves to the next audio source in your network.
4 Adjust the volume level on your wireless subwoofer by turning the Volume knob
clockwise or counterclockwise. The level should be set so that the bass volume level best
matches the volume level of the rest of your audio system.
5 Note that some Rocketboost enabled devices (for example, the Insignia NS-SBAR/NS-
SBAR-A soundbar) send both a subwoofer signal (volume controlled by the sending
device) and a second room audio signal (not volume controlled by the sending device).
To conrm you are connected to the subwoofer signal, turn the volume up and down at
the sending device (for example, the Insignia NS-SBAR/NS-SBAR-A soundbar), and
listen to make sure that the subwoofer volume level changes. If it does not, press Next
Source on the subwoofer to select the other audio signal from the sending device.
For more information see your User Guide for your other Rocketboost enabled product.
One-year limited warranty
Visit www.insigniaproducts.com for details.
Contact Insignia:
For customer service, call 1-877-467-4289
www.insigniaproducts.com