Filter
Top Products
9
NS-S5250 5¼" 3-way 60-Watt Car Stereo Speakers
www.insignia-products.com
3 Slide the screw clips over the screw holes so the holes in the clips
align with the screws holes in the vehicle panel.
4 Insert the speaker into the hole, then align the screw holes in the
speaker with the screw holes in the vehicle panel.
5 Insert the screws into the screw holes.
6 Gradually tighten the screws. Make sure that you tighten the
screws evenly so you do not warp the speaker frame.
To test the speakers:
1 Reconnect the negative terminal on the vehicle battery, then turn
on the vehicle.
2 Make sure that the volume on your audio system is turned down,
then turn on your audio system.
3 Gradually increase the volume.
To install the speaker grills:
1 Place the speaker grill over the speaker so the screws holes in the
grill align with the screw holes in the speaker frame. Make sure
that the grill fits securely against the speaker frame. There should
not be any gaps or holes between the grill and the frame.
2 Insert screws into the screws on the grill, then carefully tighten the
screws.
0.295" (7.5 mm)
(from edge to
screw hole
center)
Clip
NS-S5250.fm Page 9 Friday, January 19, 2007 12:22 PM