Filter
Top Products
3
www.insignia-products.com
Insignia NS-S6901
6'' × 9'' Car Stereo
Speakers
Introduction
Congratulations on your purchase of a
high-quality Insignia product. Your NS-S6901
Car Stereo Speakers represent the state of the
art in car speaker design, and are designed for
reliable and trouble-free performance.
Safety information
•This
User Guide
contains important
instructions for your safety. Make sure that
you refer to it.
• Do not install the speakers where they may
be subjected to excessive heat, moisture, or
dust, or where they will be kicked repeatedly,
brushed, or bumped.
• To prevent a short circuit, never leave any
metal objects, such as coins or metal tools,
inside the acoustic system.
• Make absolutely sure that the positive (+) and
negative (-) terminals of the speakers are
connected to the correct outputs from the
music source.
• Never run the wiring on the outside of, or
under, the vehicle, where it can be damaged
by road hazards or moving parts of the
vehicle. Use existing wire channels, sills,
panels, and moulding strips inside the vehicle
to hide the wiring for safety and a neat
appearance.
• When your speakers are connected, turn on
the various components and slowly turn up
the volume. Make sure that you check and
double-check all connections to insure
correct installation and use.
• Do not overload the speakers beyond their
nominal power handling capacity.
• Keep recorded tapes, watches, and personal
credit cards using magnetic coding away
from the speakers to protect them from
damage caused by the magnets in the
speakers.
• If you cannot find an appropriate mounting
location, consult your car or sound system
dealer before mounting.
Features
Included:
• 6'' × 9'' speakers (2)
• Speaker wire mounting leads
• Mounting screws (8)
• Mounting clips (8)
Dimensions
Troubleshooting
Always test the speakers and speaker wires.
Make sure that the speakers are connected with
the correct polarity (positive (+) amplifier output
to positive (+) speaker terminal and negative (-)
amplifier output to negative (-) speaker terminal).
Specifications
Warning
• Before mounting the speakers and connecting
the wires, make sure that the negative battery
cable is disconnected from the battery. Failure
to do this may cause a short circuit or fire.
• Use extreme caution when working near the
gas tank, gas lines, or hydraulic lines with
electrical wiring.
Frequency 60-20 kHz
Sensitivity 90dB/W/M
Peak power 150 W
Magnet 30 oz.
Voice coil 1.38 in (35 mm)
Woofer Electroplate IMPP cone
Midrange and
Tweeter
2.28 in (58 mm) Mylar dome tweeter, 1.18 in
(30 mm) Mylar dome tweeter, and .78 in
(20 mm) piezo tweeter
Impedance 4 ohms
7/26 in
184.5 mm)
4.72 in
(120 mm)
6.02 in
(153 mm)
3.89 in
(99 mm)
3.13 in
(79.5 mm)
8.74 in
(222 mm)
4.76 in
(121 mm)
0.177 in
(4.50 mm)
6.57 in
(167 mm)
10.35 in
(263 mm)