iSimple Car Stereo System Car Stereo System User Manual


 
4
For Best Performance Have It
Professionally Installed.
A division of AAMP of America™
13190 56th Court Clearwater, Florida 33760
Ph. 866-788-4237
support@iSimpleSolutions.com
©2009 AAMP of Florida, Inc.
www.iSimpleSolutions.com
Within the rst 12 months from date of purchase, subject to the conditions above,
iSimple
®
will repair or replace the product at our discretion, if it is defective in
material or workmanship providing it is returned to an Authorized iSimple
TM
dealer,
with PROOF OF PURCHASE from an authorized iSimple
®
dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during
operation. Exposure to direct sunlight or extreme heat may cause damage or malfunction.
FCC Class B Radio Frequency Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installa-
tion. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
1. Re-orientate or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that of which the receiver is connected.
4. Consult the dealer or an experienced radio / television technical for help.
Notice : The changes or modications not expressly approved by the party responsible
for compliance could void the user authority to operate the equipment.
“Made for iPod” means that an electronic accessory has been designed to connect specically to iPod and has been certied
by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
“Works with iPhone” means that an electronic accessory has been designed to connect specically to iPhone and has been
certied by the developer to meet Apple performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
iPhone is a trademark of Apple Inc.