Filter
Top Products
9
9. Warranty
One Year Limited Warranty
The quality controls used in the manufacture of this product will ensure your
satisfaction. This warranty applies only to the original purchaser of this prod-
uct from an authorized iSimple
®
dealer. This warranty covers any supplied or
manufactured parts of this product that, upon inspection by iSimple
®
autho-
rized personnel, is found to have failed in normal use due to defects in mate-
rial or workmanship. This warranty does not apply to installation expenses.
Attempting to service or modify this unit, operating this unit under conditions
other than the recommended voltage will render this WARRANTY VOID.
Unless otherwise prescribed by law, iSimple
®
shall not be liable for any
personal injury, property damage and or any incidental or consequential
damages of any kind (including water damage) resulting from malfunc-
tions, defects, misuse, improper installation or alteration of this product. All
parts of this iSimple
®
product are guaranteed for a period of 1 year as follows:
Within the rst 12 months from date of purchase, subject to the conditions
above, iSimple
®
will repair or replace the product at their discretion, if it is defec-
tive in material or workmanship providing it is returned to an Authorized iSimple
®
dealer, with PROOF OF PURCHASE from an authorized iSimple
®
dealer.
Warning:
This equipment may be reset by unintentional electrostatic discharge during
operation. Exposure to direct sunlight or extreme heat may cause damage or
malfunction.
FCC Class B Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television recption, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorientate or relocate the receiving antenna.
2. Increase the separation between the equipment and reciever.
3. Connect the equipment into an outlet on a circuit differant from
that of which the reciever is connected.
4. Consult the dealer or an experienced radio / television technical
for help.
Notice : The changes or modications not expressly approved by the party
responsible for compliance could void the user authority to operate the
equipment.