Filter
Top Products
5
A. Locate factory Power antenna wire in radio’s wiring
harness. This wire will be in Pin location #18 (See
Diagram)
B. Cut this wire about 2 inches from the back of the
radio.
C. Carefully remove about ½ an inch of insulation from
the wire on the VEHICLE’S
side. (Not the wire connecting into the radio)
D. Locate the accessory wire Pin location # 20 (See
diagram)
E. About 2 inches away from the radio carefully remove
about ½ an inch of insulation from this accessory wire.
F. Connect the vehicle’s side of the Power antenna wire(stripped) to the accessory
wire. (solder this connection to ensure the best connection possible)
G. Insulate this new connection on the Accessory wire to prevent an electrical short
7. If connecting the Satellite Radio tuner (SCC1 sold separartely), make the folllowing
connections before connecting the PXAMG to the vehicle. Plug the black end of the
3 foot PXAMGSR (8-Pin mini-din to 8-Pin mini-din; sold seperately) into the second
port (closest to the dipswitches) on the Media GateWay. If you are installing the
Satellite Radio Tuner with the HDRT, connect the PXAMGSR cable to the port
farthest from the dipswitches. Connect the gray end of this cable into the Satellite
Radio tuner.
8. If connecting the ISBT21 (sold separartely), make the folllowing
connections before connecting the PXAMG to the vehichle. Plug the 3 foot
ISBT21 Cable (8-Pin mini-din to 8-Pin mini-din) cable into the rst port (farthest
from the dipswitches) on the Media GateWay. Connect the other end of this cable
into the ISBT21. Connect the microphone cable into the 3.5 mm
connection on the ISBT21.
9. Plug in the male connectors on the PGHTY1 harness into the 12-pin port on the
back of the radio. Next, connect the factory 12-pin harness (if present) into the
female connector on the PGHTY1 harness. Be sure to make a rm connection but
do not force it. Plug the Black micro-t 24-pin connector on the PGHTY1 harness
into the PXAMG Media GateWay box.
10. To complete the installation secure the Media GateWay (PXAMG) and HD Radio
tuner (HDRT if equipped) into the cavity in the dash behind the radio. Be sure that
the cables and interface modules are not near moving parts or sharp metal edges
as they may damage the cables. To prevent rattling noises inside the dash, use zip
ties, tape, or other fasteners to mount the interfaces securely.
11. With all connections made, reconnect the vehicle’s battery, insert the key into the
ignition, and turn the vehicle on. Check for proper operation of the Media GateWay
and HD Radio tuner before reinstalling the factory dash panels.
12. Note: The rst time you access the GateWay, your radio may display “DEV INIT”
while the device is initializing. If this is displayed, please wait one minute then
cycle the ignition off and on. Then access SAT mode again to begin normal
GateWay operation.