Filter
Top Products
INTERMOUNT III*
MOUNTING RINGS
The GTO607C is packaged with two
different speaker adapters. The adapters
will allow the speakers to be installed into
various factory 6," 6-1/2" and 6-3/4" openings.
The metal adapter can be mounted in many
European vehicles, Japanese vehicles or
vehicles with 6" speaker locations. The
plastic adapter can be mounted in many
vehicles using 6-3/4" speaker locations or
three-point mounting frames.
Figure 3. Mounting the GTO607C using the
supplied metal adapter. Mounting with the
plastic adapter is similar.
Figure 4. Mounting the GTO607C woofer
without the metal adapter.
FLUSH-MOUNT
Figure 5A. Mounting the tweeter using the
I-Mount flush-mounting kit.
SURFACE-MOUNT
Figure 5B. Mounting the tweeter using the
I-Mount surface-mounting cup.
TWEETER ANGLE
Figure 6. Aim the tweeter at the listening
position by sliding the screw in the groove
on the back of the tweeter cup and lock the
tweeter in place using the small retaining
screw. Rotate the entire assembly in the
mounting surface and tighten the large
hand nut.
Figures 7A through 7D. The Starfish
™
tweeter mount is intended to be used
when the tweeter will be installed behind
a factory grille (e.g., replacing the factory
tweeter behind a door panel). The Starfish
will allow you to mount the component
tweeter directly to the panel itself or to the
area behind the panel. The six mounting
tabs can be removed easily to create a
number of custom configurations.
Note: Check screw clearance before
installing. Use glue if clearance is an issue.
Note: Not all possible mounting
configurations are shown.
Figure 7A. Surface-mounted behind
grille panel.
Figure 7B. Flush-mounted to surface behind
grille panel.
Figure 7C. Mounted to grille panel.
Figure 7D. In-dash location
(may require gluing).
3
INSTALLATION
2
3
(
—) SMALL LUG
(+) LARGE LUG
BLACK
RED
RED (+)
RED (+)
BLACK (—)
BLACK (—)
1
ATTACH BASE
WITH SCREWS, THEN:
1
2
3
FOAM GASKET
MOUNTING RING
FOAM GASKET
1
S
LIDE SCREW UP OR
D
OWN TO ADJUST
TWEETER ANGLE.
4
SECURELY TIGHTEN
THE LARGE HAND NUT.
2
TIGHTEN SCREW TO
LOCK ANGLE SETTINGS.
3
ROTATE ENTIRE ASSEMBLY
TO AIM ANGLED TWEETER
TOWARD LISTENER.
*patent no. 6,505,705