Filter
Top Products
2
Amplifier Features
• 4-, 3- or 2-channel operation (P-7540),
2- or 1-channel operation (P-7520),
mono Class-D subwoofer channel
(P-2510)
• Simultaneous stereo and mono opera-
tion (P-7520, P-7540)
• Built-in 12dB/oct variable electronic
crossover
• Balanced differential input
• Front and rear summing inputs (P-2510)
for non-fading bass
• Pre-amp outputs with crossover
(P-7520, P-7540)
• Oversized Floating Rail Mosfet Power
Supply
• Universal Interface
• Common Sense turn-on
• Variable Input Sensitivity (250mV–4V)
• Fully complementary, direct coupled
discrete power amplifier circuitry
• Ultraefficient Class-D subwoofer ampli-
fier (P-2510)
• Gold-plated power, input and output
connectors
• 2-Ohm stable (stereo)
• JBL badge lights when amp is operat-
ing and flashes when protection circuit
is activated
• Made in USA
About This Manual
To attain maximum amplifier perfor-
mance, we encourage you to read the
remaining pages before installing and
operating your new JBL Power Series
amplifier. Especially review the
Applications section for ideas on design-
ing and expanding your system. Also,
save these instructions for future refer-
ence. Important: Installation of automo-
tive stereo components can require
extensive experience in performing a
variety of electrical and mechanical pro-
cedures. Although these instructions
explain how to install a JBL Power Series
amplifier in a general sense, they do not
show the exact installation methods for
your particular vehicle. If you do not have
the experience, do not attempt the instal-
lation yourself; instead ask your
Authorized JBL Car-Audio Dealer about
professional installation options.
Installation Precautions and Notes
The JBL Power Series amplifiers have
five levels of circuit protection that moni-
tor the amplifiers and will shut them
down if the electrical-system voltage
drops below 5Vdc or exceeds 18Vdc, tem-
peratures are above 194° F (90° C), short
circuits occur or current draw exceeds
product specifications. For best perfor-
mance, check the intended mounting site
to make sure the operating environment
does not create conditions that will trig-
ger circuit protection.
• Prior to installation, turn off all audio
systems and other electrical devices.
Also disconnect the (–) negative lead
from the vehicle’s battery.
• At the installation site, locate and make
a note of all fuel lines, hydraulic brake
lines and electrical wiring. Use extreme
caution when cutting or drilling in and
around these areas.
• Check clearances on both sides of a
planned mounting surface before
drilling any holes or installing any
screws. Remember that mounting
screws can extend behind the mount-
ing surface.
Thank you for purchasing your new
JBL Power Series™ amplifier. Power
Series amplifiers feature the latest
advances in discrete-circuit topology,
ensuring low distortion and superbly
clean and clear sound quality. In addition
to RCA-type pre-amp inputs, Power
Series amplifiers feature Universal
Interface™, designed to facilitate integra-
tion with factory-installed audio systems
for distortion-free performance that rivals
conventional pre-amp connections.
Included in the Universal Interface circuit
is Common Sense™ turn-on. Common
Sense turn-on senses the common-mode
voltage present on the speaker outputs of
factory and aftermarket radios, turning on
the amplifier without a separate remote
wire. All Power Series amplifiers feature
built-in electronic crossovers and pre-
amp outputs for easy system expansion
without requiring outboard processors.
P-7520/7540/2510 OM copy 7/14/98 11:46 AM Page 2