Filter
Top Products
POWER 5500 5-Channel Amplifier
2
Features and Specifications
Your new Jensen Power mobile stereo power amplifier is the amplifier of
choice for the high demands of auto sound reproduction. With its deep-bass
reproduction and plenty of reserve power, low harmonic distortion and neutral
reproduction, the Power series of amplifiers takes Mobile Hi-Fi to new heights.
Like all Jensen products, when it comes to accurate sound reproduction the
Power series takes a back seat to no one. Jensen will bring your Hi-Fi
experience to new heights with the following features:
• MOSFET Power Supply
• High Current Bi-Polar Output Transistors
• Optimized Class B Design Minimizes Distortion and Reduces Idle Current.
• Easily Drives 2-Ohm Loads
• Fullrange Highpass Filter: Continuously Variable 16Hz ~160Hz
• Subwoofer Infra-Sonic Filter: Continuously Variable 16Hz ~60Hz
• Subwoofer Low Pass Filter: Continuously Variable 30Hz~160Hz
• Subwoofer Bass EQ Filter: Continuously Variable 0~12dB @ 45Hz
• Short Circuit, DC-Offset and Thermal Overload Protection Circuitry
• Diagnostic LED's: Green - Power, Red - Standby / Fault
• Remote Input Level Control (For subwoofer channel) w/ 5 Meter Cable
Specifications
• Load Impedance - 2/4 Ohm
• Frequency Response - 10~60kHz (Subwoofer - 16~160Hz), -3dB
• THD+N @ 1kHz, 5 Watts - 0.02%, 4-Ohm, 14.4VDC
• Stereo Separation @ 1kHz - >60dB
• Signal to Noise Ratio - >100dB (Rated Power)
• Input Sensitivity - 400mV~5V
• Input Impedance - 20kOhm nominal
• Fuse - 1 x 70 Amp MAXI Fuse
• Size - L22" x H2.5" x W9"
• Weight - 10.8lbs
Power Output
RMS Power Output @ 2% THD+N, 1kHz, 14.4VDC
4 Channels
4 x 70 Watts 4-Ohm
4 x 90 Watts 2-Ohm
Bridged Stereo
2 x 180 Watts 4-Ohm
Mono - Subwoofer
1 x 200 Watts 4-Ohm
1 x 300 Watts 2-Ohm
Specifications subject to change without notice.