Filter
Top Products
CD6112
4
FRONTSP
PurplePurple/Black
Stripe
GrayGray/Black
Stripe
White/Black
Stripe
White Green/Black
Stripe
Green
Left Speaker
(Front)
Right Speaker
(Front)
Left Speaker
(Rear)
Right
Speaker
(Rear)
Black
Yellow
Blue
Red
REARSP
Aux-in
R (Red)
L (White)
Rear Lineout
R (Red)
L (White)
Gray
Fuse (15 amp fast blowATO)
PowerAntenna
Connect to power antenna or amplifier.
If not used, tape bare end of wire.
Accessory/Ignition
Connect to existing radio wire
or radio fuse.
Ground
Connect to ground terminal
or clean, unpainted part
of chassis.
Memory/Battery
Connect to battery or 12 volt
power source that is always live.
The radio will not work if this
wire is not connected.
Antenna
Connect the antenna plug
from the existing antenna
cable (some vehicles
require an adaptor).
WIRING DIAGRAM
NOTE: The amplifier in this radio is only designed for use with four
speakers. Never combine (bridge) outputs for use with two speakers.
Never ground negative speaker leads to chassis ground. Failure to
wire exactly as shown may cause electrical damage to the radio.
NOTE: Only connect speakers rated in the load impedance of 4 ohms.
Speakers with a load impedance less than 4 ohms could damage the
unit.