Filter
Top Products
SD1411
6
WIRING
1. Power Antenna (dark blue wire) - Connect
to power antenna or amplifier. If not used,
tape bare end of wire.
2. Accessory/Ignition (red wire) - Connect to
existing radio wire or radio fuse.
3. Ground (black wire) - Connect to ground
terminal or clean, unpainted part of
chassis.
4. Memory/Battery (yellow wire) - Connect to
battery or 12 volt power source that is
always live. The radio will not work if this
wire is not connected.
5. Antenna Connector - Connect the antenna
plug from the existing antenna cable
(some vehicles require an adaptor).
6. Outputs to Amplifier (gray RCA cables) -
Connect line out for optional external
amplifiers. The red connector is for the
right and the white connector is for the left.
7. Left Front Speaker
8. Right Front Speaker
9. Left Rear Speaker
10. Right Rear Speaker
11. Auxiliary Input
Gray/Black (-)
Gray (+)
8
White/Black (-)
White (+)
Violet (+)
1
3
2
+
4
7
9
10
Green (+)
Green/Black (-)
Violet/Black (-)
Gray
Yellow
Dark Blue
Black
6
Red
5
15
Yellow
11
Fuses
When replacing a fuse, make sure the
new fuse is the correct type and
amperage. Using an incorrect fuse could
damage the radio. The SD1411 uses one
15 amp fuse located below the wiring
connector (15 amp fast blow ATO).
NOTE: The amplifiers in this radio are
only designed for use with four
speakers. Never combine (bridge)
outputs for use with two speakers.
Never ground negative speaker leads
to chassis ground. Failure to wire
exactly as shown may cause electrical
damage to the radio.