Filter
Top Products
WARNING! Only connect the unit to a 12-volt power supply with proper grounding.
Complete wiring as illustrated in the wiring diagram on page 4. Once the wiring is complete,
reconnect the battery negative terminal. If there is no ACC available, connect the ACC lead to the
power supply with a switch.
NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging
the radio. The VM9213 uses one 15 amp fuse, located in the black filter box in-line with the
main wire harness.
Remove mounting sleeve brackets.
Remove trim ring.
Mount factory brackets on new radio using existing
screws from old radio.
Slide radio chassis into dash opening and secure.
Re-install dash panel.
ISO-DIN Installation
4
5
3
2
1
2
1
3
4
5
Wiring
Connect wiring adapter to existing wiring harness.
Connect antenna lead.
Carefully slide the radio into the mounting sleeve,
making sure it is right-side-up, and secure with the
original 4 screws.
Attach one end of the perforated support strap
(supplied) to the screw stud, which is screwed into
the threaded insert on the back of the unit, using the
hex nut provided. Fasten the other end of the
perforated strap to a secure part of the dashboard
either above or below the radio using the screw and
hex nut provided. Bend the strap to position it as
necessary.
Replace any items you removed from the dashboard.
CAUTION! The rear of the radio
must be supported with the strap to
prevent damage to the dashboard
from the weight of the radio or
improper operation due to
vibration.
NOTE: For proper operation of the
CD/DVD player, the chassis must be
mounted within 20° of horizontal.
Make sure the unit is mounted
within this limitation.
Final Installation
1
1
2
2
3
3
4
4
5
5
After completing the wiring connections, turn the unit on to
confirm operation (ignition switch must be on). If unit does
not operate, recheck all wiring until problem is corrected.
Once proper operation is achieved, turn off the ignition
switch and proceed with final mounting of the chassis.
Remove Mounting
Sleeve Brackets
3