JL Audio C2-690tx Car Speaker User Manual


  Open as PDF
of 8
 
4 | JL Audio - C2-690tx Owner’s Manual
SPEAKER INSTALLATION
Thespeakershouldbeinstalledinoneofthe
followingwaysdependingonlocation:
Bottom-Mount Locations:Ifyouwillbeusing
thefactoryspeakerwires,itmaybenecessaryto
changetheterminations.Thismaybeaccomplished
byusinganadaptorplugorsimplybycuttingthe
factoryconnectoroffandusingthesuppliedcrimp
connectorstoterminatethespeakerwires.The
largeconnectorisforthepositiveterminalandthe
smallconnectorisforthenegativeterminalofeach
speaker.Youmayalsochoosetorunnewspeaker
wires.Whichevermethodyouchoose,observe
correctpolarityinyourconnections.Ifyouare
unsureaboutanyoftheseissues,contactyour
JLAudiodealerforinstallationassistance.
WARNING
!!
Double check the clearance for both speakers
before proceeding. Many cars are different from
one side to the other!
Yournewspeakershavebeendesignedtoinstall,
withoutmodifications,intomostvehiclesthataccept
a6x9inchspeaker.Mostfactory6x9inchspeakers
usefourmountingscrewsorboltswhichwilllineup
withthemountingholesonyourC2-690txspeakers.
Thespeakershouldfitsothatnoairleaksaround
themountingflange.Airleakswillcauseasevere
degradationinsoundquality.
Sealanyairleakswithsilicone,ropecaulkor
similarsealantmaterial.Installasshowninthe
diagramhere,usingthesuppliedbottom-mount
spacerringsandthesuppliedscrewsandmounting
clips.Hand-tightenthescrewsevenlytoavoid
bendingthespeakerframe!
WARNING
!!
Hand-tighten the screws evenly in a criss-cross
pattern to avoid bending the speaker frame or
stripping the mounting clips.
 previous next