Filter
Top Products
6 JL Audio
“REMOTE” TURNON
The J2-250.1 is turned on and off
using a conventional +12V remote turn-
on lead, typically controlled by the
source unit’s remote turn-on output.
Made in China
Speaker Output (Mono)Ground FUSE
30A
Remote+ 12VDC
The amplifier will turn on when +12V is
present at its “Remote” input and turn off when
+12V is switched off. If a source unit does not
have a dedicated remote turn-on output, the
amplifier’s turn-on lead can be connected to +12V
via a switch that derives power from an ignition-
switched circuit.
18 AWG wire is more than adequate for
the remote turn-on connection. To connect
the remote turn-on wire to the amplifier, strip
1/2-inch (12 mm) of insulation from the wire
and insert it into the “Remote” receptacle on the
power connector. Tighten the connector down
using a Phillips screwdriver.
“AMPLIFIER INPUTS”
The J2-250.1 offers two input connection
methods, one for high-level (speaker level) signals
and one for low-level (preamp level) signals.
LP Filter Frequency (Hz)Input Sens. Bass Boost
Power Protect
Remote
Level Port
LEFT
RIGHT
LEFT
RIGHT
Preamp
Outputs
Amplifier
Inputs
min max 60 240 O +9dB
High-Level Inputs
You may run a stereo or a mono signal into
the inputs of the amplifier. The amplifier’s input
section automatically sums stereo signals to mono
for the internal amplifier section.
The amplifier will operate with only one
input connection (left or right), but will require
an increase in input sensitivity to overcome the
loss of signal. If a mono input signal is to be run
into the RCA jacks, we recommend that you use
a “Y-adaptor” to split the mono signal into both
the Left and Right inputs of the amplifier.
1) Low-Level Inputs: A standard left/
right pair of RCA type jacks in the
“Amplifier Inputs” section is used for
preamp level (low-level) signal input
on the J2-250.1. This is the preferred
connection method whenever available.
2) High-Level Inputs: If your system does not
offer a preamp level signal option, you can
connect speaker level signals directly to the
“High-Level Inputs” connector using the
supplied mating connector and wire harness.
Simply splice the appropriate left/right and
positive/negative wires to the included harness
and plug the harness into the “High-Level
Inputs” connector on the amplifier. The
J2-250.1 will attenuate the high-level signal to
make it compatible with its input stage.