JL Audio SB-B-3SER/CPE/SDN/13TW5 Car Speaker User Manual


  Open as PDF
of 2
 
SB-B-3SER/CPE/SDN INSTR_SKU# 011256
S T E P 5
Set the enclosure into the trunk with the woofers facing
down, attach the wires going to the amplifier. Push the
enclosure towards the seat, and tilt it up so that it rests fully
against the seat. Install the silver bolts, split lock washers
and flat washer through the slots in the previously installed
brackets into the Stealthbox®, apply pressure to the enclo-
sure so that the bolts go through the slots as close to the
seat as possible and tighten all bolts.
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
S T E P 4
Using the hardware assembled in STEP 3, install two mount
brackets where bolts were removed in STEP 2. Do not
tighten the bolts down yet, just get them snug. The slotted
end of the bracket should point down and towards the rear
of the car.
Page 2 • JL Audio, Inc 2008
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 011256 8-12-2008 • Printed in USA • ©2008 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
(954) 443-1100
www.jlaudio.com
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A
I N C L U D E D H A R D W A R E
(2) 8mm- 1.25 x 35mm Black Oxide Hex Head Bolt
(2) 8mm- 1.25 x 22mm Chrome Hex Head Bolt
(4) 8mm Flat Washer
(4) 8mm Split Lock Washer
(2) Custom Mount Brackets
(2) 3/4" Aluminium Spacers
S P E C I F I C A T I O N S
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 13TW5-3
Nominal Impedance: Dual 3 ohms
Continuous Power Handling: 600 Watts (per woofer)
P O W E R R E C O M M E N D A T I O N
JL Audio recommends using a high quality amplifiers such as the JL Audio HD750/1 or the 500/1v2. The diagram
below shows the recommended crossover, infrasonic filter and equalizer settings for the 500/1v2. when being used
to power your Stealthbox
®
.
The JL Audio 500/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifiers.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of your vehicle.
Front Speaker Size / Location: 4" In the doors
Fits JL Audio Models: N/A
Rear Speaker Size / Location: Coupe-6.5"/Rear Deck Sedan-5.25"/rear doors....4" Rear Deck
Fits JL Audio Models: TR650-CXi, TR650-CSi, VR650-CXi, TR650-CXi,TR650-CSi, VR650-CSi, C5-650, C5-650x,
ZR650-CSi (Coupe) TR525-CXi, TR525-CSi, VR525-CXi, TR525-CXi, TR525-CSi, VR525-CSi, C5-525, C5-525x,
ZR525-CSi......TR400-CXi (Sedan)
Towards back of
car >
+12VDC Ground Remote Preamp Output Section
Infrasonic Filter
“Q” Center Freq. Boost (dB)
Amp LP Filter
Advanced
Bass
Control
Amplifier Input Section
Subwoofer Output
MONO OUTPUT ONLY
Left Output Right Output Left Ch. Right Ch.Filter Freq. (Hz) Filter Freq. (Hz)Infrasonic Freq. (Hz) Remote Bass Port
Full Range
|
Amp Filter
|
Out Filter
Output Mode Filter Slope Mode
Mode
|
Slope
Input Voltage Input Sens. Signal Sensing
12dB
|
24dB
Filter Mode
LP
|
HP
Bass EQ
Off
|
On
Off
|
12dB
|
24dB Low
|
High Off
|
OnOff
|
On
40
45
55
65
80
100
200 15
18
22
30
45
55
60 40
45
55
65
80
100
200
0.5
0.7
1.1
1.6
2.7
4.3 20
25
30
40
60
75
80 0
+4
+10
+13
+15
500/1v2
Monoblock Subwoofer Amplifier
 previous