Filter
Top Products
SB-D-CLBR/10W1v2_INSTR_SKU#011236
SB-D-CLBR/10W1v2_INSTR_SKU#011236
CONGRATULATIONS
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
STEP 14
Place the plastic flooring and rear sill plate back into place,
from STEP 3.
Mount the right side rear hold down cleat back into place,
from STEP 2.
STEP 13
Place a supplied washer onto each supplied screw.
Place the supplied grille into the location of the door that
was removed in STEP 12.
From the back side cargo panel, pass each screw assembly
through a factory hole. As seen in the picture.
Secure the grille to the side cargo panel.
Place the side cargo panel back into the car, from STEP 4.
STEP 12
Remove the door that is located on the front of the side
cargo panel.
Grind off the plastic weld tabs that secure the pocket to the
back of the side cargo panel.
Page 3 • JL Audio, Inc 2007
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011236 -08-21-200
JLA-SKU#011236 -08-21-200
7
7 • Printed in USA • ©2005 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100
www.jlaudio.com
10369 NORTH COMMERCE PARKWAY • MIRAMAR, FLORIDA • 33025 • USA
INCLUDED HARDWARE
(1)
(1)
3/8-inch x 1-1/2-inch Fender Washer
3/8-inch x 1-1/2-inch Fender Washer
(1)
(1)
3-inch x 3-inch Wax Square
3-inch x 3-inch Wax Square
(1)
(1)
3/8-inch -16 x 2-1/2-inch Hex Tap Bolt
3/8-inch -16 x 2-1/2-inch Hex Tap Bolt
(1)
(1)
3/8-inch Split lock Washer
3/8-inch Split lock Washer
(1)
(1)
3/8-inch Flat Washer
3/8-inch Flat Washer
SPECIFICATIONS
Enclosure Type:
Acoustic Suspension (sealed)
Acoustic Suspension (sealed)
Driver Type:
10W1v2
10W1v2
Nominal Impedance:
4 ohms mono
4 ohms mono
Continuous Power Handling:
150 Watts
150 Watts
POWER RECOMMENDATION
JL Audio recommends using a high quality amplifier such as the JL Audio A2150.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the A2150 when
being used to power your Stealthbox
®
.
The JL Audio A2150 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
MID/HIGH FREQUENCY DRIVER FITMENT
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location:
6-inch x 9-inch / Front Doors
6-inch x 9-inch / Front Doors
Fits JL Audio Models:
TR690-TXi & VR690-CXi
TR690-TXi & VR690-CXi
Rear Speaker Size / Location:
6-inch x 9-inch
6-inch x 9-inch
/ Rear Doors
/ Rear Doors
Fits JL Audio Models:
TR525-CXi, VR525-CXi & XR525-CXi
TR525-CXi, VR525-CXi & XR525-CXi