Filter
Top Products
Sheet SKU#011118 Revision 5/21/01SB-GM-BURB/10W3 - JL AUDIO, Inc 2001 • Page 2
STEP 4: Slide the console forward to dislodge it from the rear
support bracket. Remove the console.
STEP 5: Using a 10mm socket, remove the two bolts that hold
the rear bracket to the floor. Remove the bracket from the ve-
hicle.
STEP 6: Place the two supplied 4" X 4" wax squares, sticky side down, in the approximate locations of the
Stealthbox mounting holes.
STEP 7: Thread both of the supplied 3/8" X 1 1/2" bolts fully into the threaded inserts in the bottom of
the Stealthbox.
STEP 8: Place the Stealthbox into its mounting location.
Be sure the Stealthbox is in the same relative position as the original factory console.
STEP 9: Press down firmly on the Stealthbox to leave impressions in the wax squares.