JL Audio SB-MA-3-SPD/10W3v3 Car Speaker User Manual


  Open as PDF
of 5
 
Continued on Next Page
SB-M-3-SPD/10W3v3 INSTR_SKU# 011255
S T E P 2 0
Remove screws securing rearmost edge of plastic floor sup-
port panel located across front of cargo area. install 7/8 inch
spacers with #8 x 2.25 screws to lift rear edge of panel as
shown
S T E P 1 9
Place driver’s side cargo floor panel into place and press
down over Velcro to engage and adhere strips to floor panel
bottom.
Page 4 • JL Audio, Inc 2008
S T E P 2 2
Replace OEM carpeted cargo floor panel
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation for an amplifier
recommendation and basic set-up help.
S T E P 2 1
Attach foam spacers to bottom of OEM foam cargo floor
support as shown. Place foam cargo floor support back into
original location.
C O N G R A T U L A T I O N S !
You have completed the Stealthbox® installation for the Mazda3
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier recommendation and basic set-up help.
The following steps apply ONLY if you are installing this
Stealthbox® enclosure into a MazdaSpeed3.
(continued from step 13)
 previous