JL Audio SB-N-370/10W3v3 Car Speaker User Manual


  Open as PDF
of 3
 
Continued on Next Page
SB-N-370/10W3v3 INSTR_SKU# 011306
S T E P 7
Install Allen Head Stud into Speed Nut installed inSTEP 3
S T E P 6
Secure the Custom Brackets with the supplied Hex Head
Bolt, Split Lock Washer and Flat Washer, tighten all fasteners.
S T E P 5
Once the brackets are installed, align them with the factory
installed threaded bosses as indicated.
S T E P 4
The “hooked end” of each of the Custom Brackets hooks
onto the bottom edge of the plastic trim along the front of
the hatch area of the car as shown.
Page 2 • JL Audio, Inc 2009
S T E P 9
Locate the two studs by pressing down on the carpet while
making sure that carpet remains centered.
S T E P 1 1
With the woofers removed, install the Stealthbox®, having
the Allen Head Studs come up through the bottom of the
enclosure.
S T E P 1 0
Make two small “x” cuts where the Allen Head Studs are so
that they will come up through the carpet.
S T E P 8
With both Allen Head Studs installed, put the carpet for the
rear area back into the car.
 previous