JL Audio SB-N-PTHFNDR/10W Car Speaker User Manual


  Open as PDF
of 3
 
Sheet SKU#011134 Revision 9/21/00
10369 N. Commerce Pkwy, Miramar, Florida 33025 Voice: (954) 443-1100 Fax: (954) 443-1111
SB-N-PTHFNDR/10WØ, JL AUDIO, Inc 2000 • Page 3
3/8" Bolt
Split Lock Washer
Flat Washer
Car's Sheet Metal
Enclosure Wall (fiberglass)
Threaded Insert
Molded into
Enclosure
Bead of Silicone Sealant
STEP 14: Run speaker wire to the Stealthbox location. Trim to
proper length and attach to the Stealthbox. Test the operation of
the Stealthbox.
STEP 15: Place the Stealthbox in its mounting position. While one
person positions the Stealthbox from inside the vehicle a second
person should thread the supplied
3/8" X 1 1/2" bolts, fender
washers and lock washers into the Stealthbox. Apply a bead of
sealant between the washers and the floor of the vehicle to pre-
vent leaks (see diagram at right).
STEP 16: Replace the canister making absolutely sure all lines, hoses, and wires have been reconnected.
Specifications:
Enclosure Type: Acoustic Suspension (Sealed)
Driver Type: JL AUDIO 10WØ-4 Subwoofer
Cont. Power Handling: 125 Watts
Nominal Impedance: 4Ω
Supplied Hardware:
(2) 3" X 3" wax square
(2) 3/8" X 1 1/2" Bolt
(2) 3/8" X 1 1/4" Fender Washer
(2) Split Lock Washer
IMPORTANT!!!
Once the bolts are tightened, spray undercoating onto the bolt heads to prevent rust, leaks and
loosening of the bolts over time. Failure to do so may result in severe corrosion and may present a
serious safety hazard.
This completes the installation.
 previous