JL Audio SB-T-4RNR/10W Car Speaker User Manual


  Open as PDF
of 4
 
Sheet SKU#011137 Revision 8/8/00
SB-T-4RNR/10WØ, JL AUDIO, Inc 1999 • Page 3
STEP 11: While one person adjusts the position
of the Stealthbox from inside the vehicle, a second
person should bolt the Stealthbox into place using
the supplied hardware. Before tightening the bolt
apply a bead of silicone sealant between the two
flat fender washers and the vehicle's floor pan.
Then tighten the bolts fully. See diagram at right:
This completes the installation.
P.O. Box 839004, Miramar, Florida 33083-9004 Voice: (954) 981-9497 Fax: (954) 987-7855
3/8" Bolt
Split Lock Washer
Flat Washer
Car's Sheet Metal
Enclosure Wall (fiberglass)
Threaded Insert
Molded into
Enclosure
Bead of Silicone Sealant
Specifications:
Enclosure Type: Acoustic Suspension (Sealed)
Driver Type: JL AUDIO 10WØ-4 Subwoofer
Cont. Power Handling: 125 Watts
Nominal Impedance: 4Ω
Supplied Hardware:
(1) 4" X 4" wax square
(1) 3/8" X 1 1/4" Bolt
(2) 3/8" X 1 1/4" Fender Washers
(1) Split Lock Washer
IMPORTANT!!!
Once the bolts are tightened, spray undercoating onto the bolt heads to prevent rust, leaks and
loosening of the bolts over time. Failure to do so may result in severe corrosion and may present a
serious safety hazard.
 previous