Filter
Top Products
Sheet SKU#011137 Revision 8/8/00
SB-T-4RNR/10WØ, JL AUDIO, Inc 1999 • Page 2
STEP 3: Thread the supplied 3/8" x 1 1/4" bolt into the
Stealthbox. Tighten fully.
STEP 4: Place the Stealthbox into its mounting position. When
placing the Stealthbox, lift the inside edge (speaker baffle side) to
prevent dragging the bolt across the wax square. Press down
firmly to leave a clear impression in the wax.
STEP 5: Remove the Stealthbox. There should be an indention in the wax square.
Caution: Before drilling check under the vehicle for
any brake lines, fuel lines or other potential hazards.
STEP 6: Using a 1/2" drill bit, drill a hole in the vehicle using the
indentation in the wax square as a guide.
STEP 7: Remove the wax square.
STEP 8: Remove the bolt from the Stealthbox.
STEP 9: Run speaker wire to the the Stealthbox mounting location. Trim to proper length and attach to the
Stealthbox.
STEP 10: Test the operation of the enclosure.