Filter
Top Products
Continued on Next Page
SB-POL-RGRRZR INSTR_SKU# 94456
S T E P 7
Run the cabling to the outside of the vehicle and secure
using zip-ties as shown, make sure that there is clearence for
the seat so that when it’s in place, the cabling isn’t pinched.
S T E P 6
Plug the two jacks for the included harness into the
Stealthbox®
S T E P 5
This is seen from the rear wheel looking up and to the front,
notice the expansion clamp inserted from below going up
into the enclosure from below. This will be done on each
side then the locking pins need to go into place to secure
the clamp.
S T E P 4
once both compression clamps are in place, fold the lever
down and insert the locking pin.
Page 2 • JL Audio, Inc 2009
D e t a i l
S t e P 1 0
Remove the four screws that hold up the “belly pan” on the
Drivers side of the vehicle, secure the cabling along with the
OEM Harness along this run. When completed, re-install the
removed screws.
S t e P 9
Looking down through the battery area, run the cabling
along side the large harness seen at the bottom of the
picture towards the front of the vehicle, secure the cabling as
needed to the main cable that is right next to it.
S t e P 8
Looking back from the front, run the cabling through this
access hole near the floor and, secure it as shown in the
DETAIL picture below.