Filter
Top Products
7
INPUT SENSITIVITY CONTROL
The control labeled “Input Sens.” can be used
to match the source unit’s output voltage to the
input stage of the amplifier for maximum clean
output. Rotating the control clockwise will result
in higher sensitivity (louder for a given input
voltage). Rotating the control counter-clockwise
will result in lower sensitivity (quieter for a given
input voltage.)
To properly set the amplifier for maximum
clean output, please refer to Appendix A
(page 12) in this manual. After using this
procedure, you can then adjust the “Input
Sens.” level downward if this is required
to achieve the desired system balance.
Do not increase any “Input Sens.” setting for
any channel(s) of any amplifier in the system
beyond the maximum level established during
the procedure outlined in Appendix A (page 12).
Doing so will result in audible distortion and
possible speaker damage.