JL Audio XD600/6 Car Amplifier User Manual


 
9
ENGLISH
REMOTE LEVEL CONTROL OPTIONAL
With the addition of the optional Remote
Level Control (HD-RLC), you can control the
volume of one, two or all three channel pairs of
the XD600/6 from the front of the vehicle. This
is useful for subwoofer level control, rear channel
level control, center-channel level control or even
as a master volume control for the system.
The HD-RLC connects to the jack labeled
“Remote Level Control” on the Connection Panel
of the amplifier using a standard telephone cable
(supplied with the HD-RLC). If desired, multiple
XD (and HD) amplifiers can be controlled from
a single HD-RLC controller using a simple phone
line “splitter” and multiple phone cables.
When connected to the amplifier, the
HD-RLC operates as follows. At full counter-
clockwise rotation, the audio will mute
completely. At full clockwise rotation the level
will be the same as if the HD-RLC was not
connected at all. In other words, it operates
strictly as a level attenuator.
“Remote Level Mode” Switch: This switch
allows you to assign the operation of the
HD-RLC to one, two or all three pairs of
channels. In the “A l l” position, the HD-RLC
knob will affect all three channel pairs equally.
In the “3-6” (middle) position, only the level
of channels 3, 4, 5 and 6 will be affected by the
HD-RLC knob (channels 1 & 2 will not).
In the “5&6” position, only the level of
channels 5 and 6 will be affected by the HD-RLC
knob (channels 1, 2, 3 and 4 will not).