Filter
Top Products
2.8mm
5.2mm
Connection
Speaker cord
(not supplied)
Left
Right
Receiver
or
Amplifier
Information for Users on Disposal of Old Equipment
This symbol indicates that the product with this symbol should not be
disposed as general household waste at its end-of-life. If you wish to
dispose of this product, please do so in accordance with applicable
national legislation or other rules in your country and municipality. By
disposing of this product correctly, you will help to conserve natural
resources and will help prevent potential negative effects on the
environment and human health.
This symbol is
only valid in the
European Union.
Dear customer,
This apparatus is in conformance with the valid European directives and standards
regarding electromagnetic compatibility and electrical safety.
European representative of Victor Company of Japan, Limited is:
JVC Technology Centre Europe GmbH
Postfach 10 05 52
61145 Friedberg
Germany
For Proper Installation and Use
Be sure to install the speakers according to the directions so as to prevent them from
slipping accidentally out of position due to the repeated impact of opening and closing
doors or the tossing and bumping of the vehicle.
Set the wiring firmly on the floor of the vehicle, taking the utmost care not to break wires
while installing. When installing the speakers in the doors, extra attention must be paid to
allowing reasonable play to the wires. The wiring, if given too much clip or clamp, will get
pinched in between the door and body of the vehicle when opening and closing doors.
Since the speaker installed in the door is positioned at the foot level, be careful not to
damage the speaker by giving it an inadvertent kick. Check the water outlet at the bottom of
the door occasionally to ensure that it drains well, leaving no rainwater inside the door.
Before connecting the speakers to the amplifier, confirm that the power has been turned off.
The click noise generated by the connection if the power is on may damage the speakers.
The amplifier and speakers should be connected between corresponding terminals, i.e. “left”
to “left”, and “right” to “right”, as well as “+” to “+”, and “–” to “–”. Connection with reversed
polarity will degrade the quality of stereo reproduction.
Do not subject the speakers to excessive input. Any excessive input may damage the
speakers.
Make sure that the output impedance of the amplifier’s speaker terminal is rated at 4 ohms.
When cleaning the speakers, use a soft cloth and wipe the surface gently. Do not apply
thinner or solvent.
1.
2.
3.
4.
5.
6.
7.
8.
CS-WD85_A5.indd 2 7/4/2006 9:58:09 AM