Filter
Top Products
36
ENGLISH
4
Move the cursor to the next (or
previous) character position.
5
Repeat steps 3 and 4 until you finish
inputting the name.
6
Finish the procedure while the last
selected character is flashing.
To erase the input characters
Insert spaces using the same procedure
described above.
Available characters
Notes:
• When you try to assign a name to the 41st disc,
“NAME FULL” appears on the display. (In this
case, delete unwanted names before assignment.)
• When the CD changer is connected, you can assign
names to CDs in the CD changer. These names can
also be shown on the display if you insert the CDs in
this unit.
• These characters are also used while showing ID3
tags of the MP3 disc.
Some characters or symbols will not be shown
(and be blanked) on the display.
(Ex. “ABCå!d#” ]“ABCA D ”)
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z
space
0 1 2 3
4 5 6 7 8 9
–
/
<
>
Assigning names to the sources
This section is only for KD-LH7R.
You can assign names to discs (both in this unit
and in the CD changer).
After assigning a name, it will appear on the display
when you select the source.
1
Select a source you want to assign a
name to.
When you select a source,
the power automatically
comes on.
2
Press and hold SEL (select) for more
than 2 seconds while pressing
DISP (D).
Ex.: When you select CD as the source
3
Select a character.
• See next column for
available characters.
* You cannot assign a name to a CD Text or an MP3
disc.
Sources Maximum number of
characters
CDs* up to 32 characters
(up to 40 discs)
EN32-37KD-LH7R_LH5R[E]f.pm5 1/18/02, 1:51 PM36