Filter
Top Products
2
ENGLISH
How to reset your unit
Press and hold both the SEL (Select) and
(Standby/On/ATT) buttons at the same time for several
seconds.
This will reset the built-in microcomputer.
NOTES: Your preset adjustments — such as preset channels
or sound adjustments — will also be erased.
If a CD is in the unit, it will eject when you reset the
unit. Pay attention not to drop the CD.
IMPORTANT FOR LASER PRODUCTS
Precautions:
1. CLASS 1 LASER PRODUCT
2. CAUTION: Invisible laser radiation when open and interlock failed or defeated. Avoid direct exposure
to beam.
3. CAUTION: Do not open the top cover. There are no user-serviceable parts inside. Leave all servicing
to qualified service personnel.
4. CAUTION: This CD player uses invisible laser radiation, however, is equipped with safety switches to
prevent radiation emission when unloading CDs. It is dangerous to defeat the safety switches.
5. CAUTION: Use of controls, adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
SEL (Select)
(Standby/On/ATT)
INFORMATION (For USA)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
EN02-03 KD-S7250/700/680[J] 26/10/01, 9:07 AM2