Filter
Top Products
37
ENGLISH
To set the Traffic Announcement
volume—TA Volume
You can preset the volume level for TA
Standby Reception. When a traffic programme
is received, the volume level automatically
changes to the preset level.
To change the FM tuner selectivity
—IF Filter
In some areas, adjacent stations may interfere
with each other. If this interference occurs,
noise may be heard.
• Auto: When this type of interference
occurs, this unit automatically
increases the tuner selectivity so that
interference noise will be reduced.
(But the stereo effect will also be
lost.)
• Wide: Subject to the interference from
adjacent stations, but sound quality
will not be degraded and the stereo
effect will not be lost.
To change the voice support system
—VSS
You can select either “Beep” or “Voice” for the
voice support system (VSS).
• Voice: Guidance is announced in the
language you have selected (see “To
select the language for the VSS
—Language” on the right column)
when you operate the unit.
• Beep: A Beep sounds when you operate the
unit.
To deactivate the VSS, select “Off” for “VSS
Level” (see below).
To adjust the VSS level—VSS Level
You can adjust the volume level of the VSS
sounds.
• By selecting “Off,” you can deactivate the
VSS.
To select the language for the VSS
—Language
You can select the language for the voice
support system—English, German (Deutsch),
or French (Français).
• The indications on the display will also be
shown in the selected language.
To select the external component to use
—Ext Input
To use the external component connected to the
CD changer jack as the playback source
through this unit, you need to select which
component to use.
• Changer: To use a JVC CD changer.
• Line In: To use any external component.
To select the telephone muting
—Telephone
This mode is used when a cellular phone
system is connected. Depending on the phone
system used, select either “Muting1” or
“Muting2,” whichever mutes the sounds from
this unit. During telephone muting, disc play
pauses.
• Muting1: Selects this if this setting can
mute the sounds while using the
cellular phone.
• Muting2: Selects this if this setting can
mute the sounds while using the
cellular phone.
• Off: Cancels the telephone muting.
To select the amplifier gain control—
Amp Gain
You can change the maximum volume level of
this unit. When the maximum power of the
speakers is less than 50 W, select “Low PWR”
to prevent them from being damaged.
• Low PWR: You can adjust the volume level
up to “Volume 30.”
• High PWR: You can adjust the volume level
up to “Volume 50.”
33-40_KD-LHX501_2_Ef.p65 2/11/04, 8:16 PM37