Filter
Top Products
46
ENGLISH
Menu items Selectable settings
(Initial setting)
System Setting
Installation
Angle
Select the angle of the unit measured by the supplied gauge. (See
also the Installation/Connection Manual.)
1
: –5.0° to 1.0°
2
: 1.0° to 6.0°
3
: 6.0° to 14.0°
4
: 14.0° to 32.0°
• It is not recommended to install the main unit at an angle of
more than 30˚; otherwise, the malfunction may result.
• Guidance is canceled when you change this setting.
WAAS/EGNOS
Select whether to use WAAS and EGNOS to increase the accuracy
of positioning.
Off
: Cancels.
On
: Activates.
Language
*5
Select the language used for on-screen information and voice
guidance.
English US, Español, Français
Reset Calibration
Reset the calibration data in the following cases:
• When you reinstall the unit to another car.
• When you change
Installation Angle
.(☞ above)
• When you replace or rotate the tires.
Once this is carried out, the calibration data is cleared. Calibration
starts when you exit from the menu. (☞ [9])
• Guidance is canceled when you reset the calibration data.
Measuring Units
Select the measuring units for distance.
km / m
,
mi / ft
Coordinates
Select the measuring units for coordinate degrees.
Deg / Min / Sec
,
Deg / Milli / Micro
Car Position
If you find your current position displayed on a wrong place on the
map, use this setting to correct your position.
Adjust the position with 4¢5∞, then the direction with 5∞.
Setup Menu (continued)
*5 This setting is shared with the Language setting in AV Menu (
☞
[90]
).
KDNXD505_J_eng.indb 46KDNXD505_J_eng.indb 46 07.6.25 4:13:12 PM07.6.25 4:13:12 PM