Filter
Top Products
2
When using the optional stay /
Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are used, they
could damage the unit.
8 mm
Bracket*
2
*
2
Pocket
Flat head screws (M5 × 8 mm)
*
2
M5 × 8 mm *
2
Screw (option)
Stay (option)
Fire wall
Dashboard
Install the unit at an angle of less than 30˚.
30˚
Removing the unit
Before removing the unit, release the rear section.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
Do the required electrical connections.
Bend the appropriate tabs to hold the
sleeve firmly in place.
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
When installing the unit without using the sleeve /
In a Toyota car for example, first remove the car radio and install the unit in its place.
TOYOTA
*
1
When you stand the unit, be careful not to damage the fuse on the rear.
*
2
Not supplied for this unit.
JVC
•
Flat head screws (M5 × 8 mm) *
2
M5 × 8 mm *
2
Bracket *
2
*
2
*
1
*
2
For KD-R306/KD-R305 /
KD-R306/KD-R305
Install1_KD-R306[U]_CT_2.indd 2Install1_KD-R306[U]_CT_2.indd 2 08.8.20 4:46:19 PM08.8.20 4:46:19 PM