JVC KD-R526 Car Stereo System User Manual


 
15ENGLISH
Menu item
Selectable setting, [Initial: Underlined]
AUDIO
SUB.W LPF *
9
LOW
55Hz
/
LOW 85Hz
/
LOW
120Hz
: Frequencies lower than
55 Hz/85 Hz/120 Hz are sent to the subwoofer.
SUB.W LEVEL
*
9
00 —
08
[
04
] : Adjusts the subwoofer output level.
HPF ON
: Activates the High Pass Filter. The unit selects the cutoff frequency to the rear
speakers. /
OFF
: Deactivates (all signals are sent to the rear speakers).
BEEP ON
/
OFF
: Activates or deactivates the keypress tone.
TEL
MUTING *
10
ON
: Mutes the sounds while using the cellular phone (not connected through
KS-BTA100). /
OFF
: Cancels.
AMP GAIN *
11
LOW POWER
: VOLUME 00 – VOLUME 30 (Selects if the maximum power
of each speaker is less than 50 W to prevent damaging the speakers.) /
HIGH POWER
: VOLUME 00 – VOLUME 50
TUNER
SSM
Displayed only when the source is “FM.” For settings, see page 7.
MONO
Displayed only when the source is “FM.” For settings, see page 7.
IF BAND AUTO
: Increases the tuner selectivity to reduce interference noises between adjacent
stations. (Stereo effect may be lost.) /
WIDE
: Subject to interference noises from adjacent
stations, but sound quality will not be degraded and the stereo effect will remain.
IPOD SWITCH
*
12
HEAD MODE
: Controls iPod playback through the unit. /
IPOD MODE
: Controls
iPod playback through the iPod/iPhone. /
EXT MODE
: The sound of any functions
(musics, games, applications, etc.) running on the connected iPod/iPhone is emitted
through the speakers connected to this unit. The display always show “EXT MODE.”
SRC SELECT
AM *
13
ON
/
OFF
: Enable or disable “AM” in source selection.
F-AUX *
13
ON
/
OFF
: Enable or disable “F-AUX” in source selection.
R-AUX *
13
ON
/
OFF
: Enable or disable “R-AUX” in source selection. /
BT ADAPTER
: Selects if
the rear auxiliary input jack is connected to the Bluetooth adapter, KS-BTA100. (page 9)
The source name changed to “BT AUDIO.”
*
9
Displayed only when <L/O MODE> is set to <SUB.W>.
*
10
This setting does not work if <BT ADAPTER> is selected for <R-AUX> of the <SRC SELECT>.
*
11
The volume level automatically changes to “VOLUME 30” if you change to <LOW POWER> with the volume level set
higher than “VOLUME 30.”
*
12
For KD-R526: Displayed only when “USB-IPOD” is selected.
*
13
Displayed only when any source other than “AM/ F-AUX/ R-AUX/ BT AUDIO” is selected separately.
EN02-19_KD-R526_005A_4.indd 15EN02-19_KD-R526_005A_4.indd 15 9/27/10 5:17:26 PM9/27/10 5:17:26 PM