JVC KD-S17 Car Stereo System User Manual


 
3– EN
INSTRUCTIONS
Audio amplifier section
Power Output:
20 W RMS × 4 Channels at 4 Ω and
≤ 1% THD+N
Signal-to-Noise Ratio:
80 dBA (reference: 1 W into 4 Ω)
Load Impedance: 4 Ω (4 Ω to 8 Ω allowance)
Tone Control Range: Bass: ±12 dB at 60 Hz
Mid-range: ±12 dB at 1 kHz
Treble: ±12 dB at 7.5 kHz
Frequency Response: 40 Hz to 20 000 Hz
Line-Out Level/Impedance: 2.5 V/20 kΩ load (full scale)
Output Impedance: 1 kΩ
Subwoofer-Out Level/Impedance:
2.5 V/20 kΩ load (full scale)
Tuner section
Frequency Range:
FM: 87.5 MHz to 107.9 MHz
(with channel interval set to 100 kHz or 200 kHz)
87.5 MHz to 108.0 MHz
(with channel interval set to 50 kHz)
AM: 530 kHz to 1 710 kHz
(with channel interval set to 10 kHz)
531 kHz to 1 602 kHz
(with channel interval set to 9 kHz)
[FM Tuner]
Usable Sensitivity: 9.3 dBf (0.8 μV/75 Ω)
50 dB Quieting Sensitivity: 16.3 dBf (1.8 μV/75 Ω)
Alternate Channel Selectivity (400 kHz): 65 dB
Frequency Response: 40 Hz to 15 000 Hz
Stereo Separation: 40 dB
[AM Tuner]
Sensitivity/Selectivity: 20 μV/40 dB
If a kit is necessary for your car, consult your telephone
directory for the nearest car audio speciality shop.
Symptoms Remedies/Causes
General
Sound cannot be heard from the speakers. Adjust the volume to the optimum level.
Check the cords and connections.
The buttons on the unit do not work as you
intended.
If you press M MODE, some buttons work differently from its
original function. Wait for 5 seconds or press M MODE again.
This unit does not work at all. Reset the unit.
FM/AM
SSM automatic presetting does not work. Store stations manually.
Static noise while listening to the radio. Connect the antenna firmly.
Disc playback
Disc ejects. Insert the disc correctly.
CD-R/CD-RW cannot be played back.
Tracks on the CD-R/CD-RW cannot be
skipped.
Insert a finalized CD-R/CD-RW.
Finalize the CD-R/CD-RW with the component which you used
for recording.
Disc can be neither played back nor ejected. Unlock the disc.
Eject the disc forcibly.
Disc sound is sometimes interrupted. Stop playback while driving on rough roads.
Change the disc.
Check the cords and connections.
“NO DISC” appears on the display.
“PLEASE” and “EJECT” appear alternately
on the display.
Insert a playable disc into the loading slot.
MP3/WMA playback
Disc cannot be played back. Use a disc with MP3/WMA tracks recorded in a format compliant
with ISO 9660 Level 1, Level 2, Romeo, or Joliet.
Add the extension code <.mp3> or <.wma> to the file names.
Noise is generated. Skip to another track or change the disc. (Do not add the extension
code <.mp3> or <.wma> to non-MP3 or WMA tracks.)
A longer readout time is required
(“READING” keeps flashing on the display).
Do not use too many hierarchical levels and folders.
Tracks are not played back in the order you
have intended.
Playback order is determined when the files are recorded.
The elapsed playing time is not correct. This sometimes occurs during playback. This is caused by how the
tracks are recorded on the disc.
The correct characters are not displayed
(e.g. album name).
This unit can only display alphabets (upper case), numbers, and a
limited number of symbols.
Microsoft and Windows Media are either registered trademarks or trademarks of Microsoft Corporation in the United
States and/or other countries.
Indication Item ( : Initial) Setting
DEMO
DEMO ON
DEMO OFF
: Display demonstration will be activated automatically if no operation is done
for about 20 seconds.
: Cancels.
CLK DISP *
6
ON
OFF
: Clock time is shown on the display at all times when the power is turned off.
: Cancels; pressing DISP will show the clock time for about 5 seconds when the
power is turned off.
CLOCK H (Hour) 112 : [Initial: 1 (1:00)]
CLOCK M (Minute) 0059 : [Initial: 00 (1:00)]
DIMMER
ON
OFF
: Dims the display and button illumination.
: Cancels.
SCROLL *
7
ONCE
AUTO
OFF
: Scrolls the displayed information once.
: Repeats scrolling (at 5-second intervals).
: Cancels.
Pressing DISP for more than one second can scroll the display regardless of
the setting.
L/O MODE
REAR
WOOFER
: Select if the REAR LINE OUT terminals are used for connecting the speakers
(through an external amplifier).
: Select if the REAR LINE OUT terminals are used for connecting a subwoofer.
WOOFER *
8
LOW
MID
HIGH
: Frequencies lower than 90 Hz are sent to the subwoofer.
: Frequencies lower than 135 Hz are sent to the subwoofer.
: Frequencies lower than 180 Hz are sent to the subwoofer.
AUX ADJ
A.ADJ 00
A.ADJ 05
: Adjust the auxiliary input level to avoid the sudden increase of the output
level when changing the source from external component connected to the
AUX input jack on the control panel.
TAG DISP
TAG ON
TAG OFF
: Shows the Tag while playing MP3/WMA tracks.
: Cancels.
AMP GAIN *
9
LOW PWR
HIGH PWR
: VOL 00 – VOL 30 (Select if the maximum power of each speaker is less than
50 W to prevent damaging the speaker.)
: VOL 00 – VOL 50
AREA
AREA US
AREA EU
AREA SA
: When using in North/Central/South America. AM/FM intervals are set to
10 kHz/200 kHz.
: When using in any other areas. AM/FM intervals are set to 9 kHz/50 kHz
(100 kHz during auto search).
: When using in South American countries where FM interval is 100kHz.
AM interval is set to 10kHz.
*
6
If the power supply is not interrupted by turning off the ignition key of your car, it is recommended that you select “OFF” to
save the car’s battery.
*
7
Some characters or symbols will not be shown correctly (or will be blanked) on the display.
*
8
Displayed only when “L/O MODE” is set to “WOOFER.”
*
9
The volume level automatically changes to “VOL 30” if you change to “LOW PWR” while the volume level is set higher than
“VOL 30.”
TROUBLESHOOTING
SPECIFICATIONS
INSTRUCTIONS
CD player section
Type: Compact disc player
Signal Detection System: Non-contact optical pickup
(semiconductor laser)
Number of channels: 2 channels (stereo)
Frequency Response: 5 Hz to 20 000 Hz
Dynamic Range: 93 dB
Signal-to-Noise Ratio: 98 dB
Wow and Flutter: Less than measurable limit
MP3 Decoding Format: MPEG1/2 Audio Layer 3
Max. Bit Rate: 320 kbps
WMA (Windows Media® Audio) Decoding Format :
Max. Bit Rate: 192 kbps
General
Power Requirement: Operating Voltage: DC 14.4 V
(11 V to 16 V allowance)
Grounding System: Negative ground
Allowable Operating Temperature:
0°C to +40°C (32°F to 104°F)
Dimensions (W × H × D):
Installation Size (approx.):
182 mm × 52 mm × 160 mm
(7-3/16” × 2-1/16” × 6-5/16”)
Panel Size (approx.):
188 mm × 58 mm × 6 mm
(7-7/16” × 2-5/16” × 1/4”)
Mass (approx.):
1.3 kg (2.9 lbs) (excluding accessories)
Design and specifications are subject to change without
notice.
Having TROUBLE with operation?
Please reset your unit
Still having trouble??
Call 1-800-252-5722 (USA ONLY)
http://www.jvc.com
General settings—PSM
Select an item. Adjust. Finish.Enter PSM menu.
Sound adjustments
Indication (For)
BAS
(bass)
MID
(mid-range)
TRE
(treble)
LOUD
(loudness)
USER (Flat sound) 00 00 00 OFF
ROCK (Rock or disco music) +03 00 +02 OFF
CLASSIC (Classical music) +01 00 +03 OFF
POPS (Light music) +02 +01 +02 OFF
HIP HOP (Funk or rap music) +04 –02 +01 OFF
JAZZ (Jazz music) +03 00 +03 OFF
Adjusting the sound
BAS*
2
(bass) : Adjust the bass. –06 to +06
MID*
2
(mid-range) : Adjust the middle frequencies sound level. –06 to +06
TRE*
2
(treble) : Adjust the treble. –06 to +06
FAD*
3
(fader) : Adjust the front and rear speaker balance. R06 to F06
BAL (balance) : Adjust the left and right speaker balance. L06 to R06
LOUD*
4
(loudness) : Boost low and high frequencies to produce a well-balanced sound
at a low volume level.
LOUD ON or LOUD OFF
SUB.W (subwoofer) : Adjust the subwoofer output level. 00 to 08
VOL (volume) : Adjust the volume. 00 to 50 (or 00 to 30)*
5
*
1
Displayed only when “L/O MODE” is set to “WOOFER.”
*
2
When you adjust the bass, mid-range, or treble, the adjustment you have made is stored for the currently selected sound
mode (iEQ) including “USER.”
*
3
If you are using a two-speaker system, set the fader level to “00.”
*
4
The adjustment made (LOUD ON/LOUD OFF) will be applied to all sound modes (iEQ).
*
5
Depending on the amplifier gain control setting.
Preset values
SETTINGS
EN_KD-S17[J]_f.indd 3EN_KD-S17[J]_f.indd 3 6/25/10 3:55:14 PM6/25/10 3:55:14 PM