Filter
Top Products
7
ENGLISH
KS-FX210 [EN] GET0052-001A [J]
Storing stations in memory
You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations
FM station automatic preset: SSM
You can preset 6 local FM stations in each FM band
(FM1, FM2 and FM3).
1
Select the FM band (FM1 – 3) you
want to store FM stations into.
Each time you press the
button, the FM band changes
as follows:
2
Press and hold both buttons for
more than 2 seconds.
Local FM stations with the strongest signals
are searched and stored automatically in the
band number you have selected (FM1, FM2 or
FM3). These stations are preset in the number
buttons — No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in button number 1 will be automatically tuned into.
3
Tune into a station you want while
“M” is flashing.
• If you release your finger from the button,
the manual mode will automatically turn off
after 5 seconds.
• If you hold down the button, the frequency
keeps changing until you release the
button.
When an FM stereo broadcast is hard
to receive:
Press MO/RND (Monaural/Random) while listening
to an FM stereo broadcast.
• Each time you press the button, the MO indicator
lights up and goes off alternately.
When the MO indicator is lit on the display,
the sound you hear becomes monaural but
the reception will be improved (the ST indicator
goes off).
To restore the stereo effect, press the same
button again.
To tune into stations
of higher frequencies.
To tune into stations
of lower frequencies.
“SSM” appears, then disappears when automatic
preset is over.
MO/RND
Lights up when receiving an
FM broadcast in stereo.
FM1 FM2 FM3
F M
ST
BEAT POP SOFT
LOUD
BEAT POP SOFT
LOUD
MO
BEAT POP SOFT
LOUD
EN06-08-KS-FX210[J]f 10/8/01, 10:14 AM7