Filter
Top Products
Front Panel
Release Button
INSTALLING THE FRONT PANEL
REMOVING THE FRONT PANEL
-- 6 --
-- 7 --
1
7
4
2
5
3
1. Dashboard
2. Nut (5mm)
3. Spring washer
4. Screw (5 x 16mm)
5. Screw
6. Strap
Be sure to use the strap to secure the
back of the unit of the place. The strap
can be bent by hand to the desired
angle.
7. Plain washer
1. Frame
2. Insert fingers into the groove in the front
of frame and pull out to remove the
frame .(When re-attaching the frame.
Point the side with a groove downwards
and attach it.)
3. Lever
Insert the levers supplied with the unit
into the grooves at both sides of the unit
as shown in figure until they click.
Pulling the levers makes it possible to
remove the unit from the dashboard.
3
1
6
4 SPEAKER WIRING4 SPEAKER WIRING
CONNECTIONS
ANTENNA
FRONT
LEFT
SPEAKER
REAR
LEFT
SPEAKER
FRONT
RIGHT
SPEAKER
REAR
RIGHT
SPEAKER
+ WHITE
- WHITE/BLACK
+ GREEN/BLACK
- GREEN
VIOLET +
VIOLET/BLACK-
GRAY +
GRAY/BLACK-
RED(R)
WHITE(L)
RED(R)
WHITE(L)
7A
1A
0.5A
FUSE
YELLOW
BACK UP
RED
B (+)
BLUE
AUTO ANT(+)
BLACK
GROUND(-)
LINE OUT
LINE IN
GRAY
BLACK
Choose the mounting location where the unit will not interfere with normal driving function.
Before finally installing the unit, connect the wiring temporarily and make sure it is all connected
properly and the unit and the system work properly.
Use only the parts included with the unit to ensure proper installation. The use of unauthorized
parts can cause malfunctions.
Consult with your nearest dealer if installation requires the drilling of holes or other modifications
of the vehicle.
Install the unit where it does not get in the driver s way and cannot injure the passenger if there
is a sudden stop. Like an emergency stop.
If installation angle exceeds 30 from horizontal,the unit might not give its optimum performance.
Avoid installating the unit where it would be subject to high temperature.such as from direct
sunlight. Lower case or from hot air, from the heater,or where it would be subect to dust, dirt or
excessive vibration.
INSTALLATION
NOTE:
DIN FRONT/REAR-MOUNT
This unit be can be properly installed either from Front (conventional DIN Front-mount) or Rear
(DIN Rear-mount installation, utilizing threaded screw holes at the sides of the unit chassis). For
detail, refer to the following illustrated installation methods.
DIN FRONT- MOUNT (Method A)
Installing the unit
1. Dashboard
2. Holder
After inserting the holder into the
dashboard, select the appropriate tab
according to the thickness of the
dashboard material and bend them
inwards to secure the holder in place.
3. Screw
1
3
2