Filter
Top Products
CAP 210 and 310/Antenna turntable
Brief Operating Instruction
936.2704/A/1204/1.2e/ZWT
Observe the safety precautions in the
UFD 170 Detailed Operating Instructions!
Maintain a clear view to the satellite!
The vehicle must be still when satellite searching (avoid physical move-
ments inside the vehicle)!
Prior to entering the vehicle, check whether the antenna is in the park
position!
•
•
•
Satellite searching
Important Information
1. First switch on the UFD 170 using the
key on the remote control (power switch must be set to „on“).
2. The following message will appear on screen
for approx. 10 seconds:
„Welcomes you“ „UFD 170“
4. Once the system has initialised, the last satel-
lite position will be located and the following
screen will appear (example only):
7. The following message appears and after just
a few seconds, you will see the selected TV
programme full-size on the screen:
5. If no satellite signal is available, the above
message will appear. Press OK to start the
search mode (the satellite name can vary
depending on the programme location, e.g.
HOTBIRD).
6. If the satellite signal is now found, a small
picture will appear in the top right of the screen.
Do not interrupt the search. The UFD 170 is
still making a fi ne adjustment to optimise
the signal reception (see screen)!
No signal
available!
Signal
available!
3. The following message will appear for approx.
20 seconds:
„Please wait!“ „HDP initializing“
Note:
You can use the F key on your remote control to start a satellite search at practically any time (exceptions: you are in a menu or
another OSD is already shown). Neither will the search start if you already have a TV signal. Press the F key and the current satellite
position will be located; if no signal is available, the OSD shown under No. 5 will appear. Proceed as described under No. 5.
•