Filter
Top Products
z All other audio devices connect to the round 3.5mm headphone
or line out socket.
Note
o Be sure to adjust the media player volume level to at least a few
steps below maximum output to ensure the signal going to the
radio is not distorted. This will also help conserve battery life.
Insert player and cushion into fairing pocket
z With the connection side of the device facing downward, insert
it into the underside slot of the supplied foam cushion. The
wider slot is designed to accommodate devices such as the
iPod. The smaller slot is sized for devices such as the iPod
nano®. Larger devices such as cassette or CD players may
require modication of the cushion or may be too large to t
inside the fairing pocket.
z Carefully coil the cable and connectors under the cushion.
Insert the cushion into fairing pocket until the upper edge of the
cushion is no more than ½” above the top of the pocket.
z Close and latch the cover.
NOTICE
Do not operate the motorcycle without rst closing and
locking the fairing pocket lid.
NOTE
o All Apple iPod devices with the 30-pin dock connector will
display song title, artist, etc and the iPod will be charged. The
iPod adapter cable is not designed to work with the iPhone™.
o If using any other media player, only volume can be controlled
and displayed.
o If using any media player that will not t inside the cushion,
care must be taken to protect it from road vibration and shock.
Removal of media player
z Remove the cushion and media player from the fairing pocket.
z Disconnect the media player from the adapter cable.
z Carefully remove the media player from the cushion.
z Replace the cushion and adapter cable in the fairing pocket.
Close and latch the cover.
Kawasaki Motors Corp., U.S.A. will not be responsible for any loss or damage to devices used with this
kit.
© Kawasaki Motors Corp., U.S.A., July 2009