Filter
Top Products
62
13
PROGRAMMABLE FUNCTION (PF) KEYS
1 Press [MNU] to enter Menu mode.
2 Press [
cc
cc
c]/ [
dd
dd
d] to select “RADIO (1–)”, then press
[OK].
3 Press [
cc
cc
c]/ [
dd
dd
d] to select “MIC (1–8–)”, then press
[OK].
4 Press [
cc
cc
c]/ [
dd
dd
d] to select “PF1 (1–8–1)” to “PF4 (1–8–4)”,
then press [OK].
5 Press [
cc
cc
c]/ [
dd
dd
d] to select the desired function.
6 Press [OK] to complete the setting.
7 Press [MNU] to exit Menu mode.
After switching the power OFF, you may press Mic [PF]+
POWER ON. This allows you to skip steps 1 to 4. Press
Mic [MR], [VFO], or [CALL] instead of [PF] as
necessary.
Note:
◆
Without an optional VS-3 unit installed or with OFF selected in Menu
1–2–4 (VOICE), pressing the PF key programmed with Voice causes
the transceiver to announce the current frequency using beeps of
different frequencies.
◆
To restore the default functions, perform Full Reset {page 41}.
]FP[ )1FP(tceleSdnaB
]RM[ )2FP(llaceRyromeM
]OFV[ )3FP(tceleSOFV
]LLAC[ )4FP(
tceleSlennahCllaC
)XTenoTzH0571:E007D-MT(
For the shaded functions, see the separate manual,
“SPECIALIZED COMMUNICATIONS”.
The Programmable Function keys are [PF], [MR],
[VFO], and [CALL] located on the face of the
microphone. These keys have the following default
functions:
If you prefer, you can change the defaults to the
following key functions:
noitcnuFyeK
.feR
egaP
noitcnuFyeK
.feR
egaP
noitcnuFyeK
.feR
egaP
B/A71VER33PETS46
ROTINOM91WOL12LAUSIV84
RETNE
,73,03
36,65
ETUM27MID56
ECIOV38LRTC71
LESDNAB-BUS
71
057123NIMP44
XD )6(
MP44.C.B.A66
CNT )11,6,4(
UNEM22MsV04
TSIL )51(
OFV51NI.M63
NOM.P )62(
RM73NI.C93
NOCB )23,52(
LLAC93KCOL76
GSM )23~03(
zHM02LES.T
75,55,03
SOP )02,91(
ENOT
75,55,03
TFIHS92
RWP
)ylno1FP(
91