Filter
Top Products
— 13 —
Direct Alphabet Input
(Function of remote with number/letter entry buttons)
Direct input can be made of letters (alphabetical) with the letter
entry buttons on the remote.
Example: Use the following table to enter the name "DANCE".
Continue steps 3 and 4 until all the characters are chosen for
the name.
You can enter up to eight characters for each name.
Assigning Names
Press the NAME.S button on the unit or the OK button on the
remote.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.
•You can assign names to up to 30 FM/AM stations in all.
If you try to enter more than that, the station name stored the
NOTE
6
NOTE
5
Button to press # Times pressed
Character
#3 1
1#2
#6 2
#2 3
#3 2
“D”
“A”
“N”
“C”
“E”
NOTE
Alphabet (upper case)/Numerals/Symbols:
A ~ Z 0~9 / + –
Alphabet (lower case)/Numerals/Symbols:
a ~ z 0~9 / + –
earliest will be the first one erased.
• When this device is disconnected from the battery SNPS is
erased.
• If you want to change the name of a station, first display the
name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.
DPX-5050_M_r1_U.S 03.1.21 0:01 PM Page 13