Kenwood DPX-5050 Car Stereo System User Manual


 
— 11 —
Press the SRC (source) button repeatedly to select the tuner
mode. "TUNER" is displayed when the tuner mode has been
selected.
Press either the FM or AM button to select the band.
Each time you press the FM button, the band switches
between the FM1, FM2 and FM3.
Press the AM button to select the AM band.
•Auto Seek Tuning
Press the ¢ button to seek higher frequencies.
Press the 4 button to seek lower frequencies.
•Preset station seek tuning
Press the ¢ button to move to the next preset station (i.e.,
the one with the next highest number), and the 4 button to
move to the last preset station (i.e., the one with the next
lowest number).
If the frequencies stored at the preset numbers receive
stations which were not originally memorized when traveling
long distances, the preset number is not displayed. In such
cases, pressing the 4/¢ button to use preset station
seek will receive channel 1.
Manual Tuning
Press the ¢ button to increase the frequency by one step.
Press the 4 button to decrease the frequency by one step.
Please see the function set system about selecting tuning
mode. (page 29)
•The ST indicator lights up when stereo broadcasts are being
received.
NOTE
NOTE
3
2
1
Tuning
When you know the frequency of the station that you want to
listen to, you can input it directly for quick access.
Select the band by pressing the FM or AM button.
1
Direct Access Tuning (Function of remote)
Press the DIRECT button.
"----" is displayed for 10 seconds.
If you make no input in the 10-second period, direct access
tuning is automatically canceled.
Enter the frequency of the desired station.
If you want to listen to an FM station at 92.1 MHz, for
example, press 9, 2, and 1.
If you want to listen to an AM station at 810 kHz, for example,
press 8, 1, and 0.
•You cannot enter frequencies above or below what a band can
receive.
•FM frequencies can only be input in 0.1 MHz steps, and not
0.01 MHz steps.
Canceling Direct Access Tuning:
Press the DIRECT button again.
NOTE
3
2
Store the frequency of a station. You can then recall that
station with a single touch of a button.
Select the band/station that you want to have stored.
Press the button (#1-6) that you want to use for the station, for
at least two seconds.
The button number blinks once in the display to indicate that
the data has been stored.
Recalling a Preset Station:
Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.
You can store six stations in each of the FM1, FM2, FM3, and
AM bands.
NOTE
2
1
Station Preset Memory
DPX-5050_M_r1_U.S 03.1.21 0:01 PM Page 11