Filter
Top Products
— 41 —
SOLUTIONPOSSIBLE CAUSEPROBLEM
A CD ejects as soon as it is
loaded.
The CD is upside-down. Load the CD with the labeled side up.
The memory is erased when
the ignition is turned off.
The battery wire has not been connected to the proper
terminal.
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
The CD is quite dirty. Clean the CD, referring to the section on "Cleaning CDs" (see
p. 5).
The sound skips on a CD. The CD is scratched or dirty. Clean the CD, referring to the section on "Cleaning CDs" (see
p. 5).
A track will not play. Random play has been selected. Turn off random play (see p. 20).
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
The ignition and battery wire are incorrectly connected.
The DSP effects are
imperceptible.
You are using a two-speaker system. Use a front/rear four-speaker system.
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
The front and rear output are reversed.
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
The + and - of speakers are reversed.
Reset the fader or balance settings (see p. 7).The fader or balance settings are set all the way to one
side.